S2GW No answer from a node

The message from S2GW if it did not receive any answer from a node over radio. This happens if the node is powered off, out of range or have incorrect radio net or ID settings.

This message is sent in a separate post. The node is removed from the list of nodes to be polled.

The node will be polled again after the configuration refresh from B3 which by default happens every 15 minutes or when configuration in B3 is changed. If it will be online, the S2GW will start polling it as defined.

<Sensor>
<SensorID>22</SensorID>
<SensorIndex>2</SensorIndex>
<SensorType>9304</SensorType>
<Time>03/24/2023 14:03:42</Time>
<ErrorCode>1</ErrorCode>
<ErrorMsg>No communication with node</ErrorMsg>
</Sensor>