BTiny MP
There are the following MP types handled by the BTiny gateway:
Battery
0 - Battery level, %
Technical MP
Cell signal
0 - GSM signal strength, %
CO2
0 - CO2 level, ppm
Humidity
0 - Rel. humidity, %
Motion
TBD
Pressure
0 - Pressure, Pa
RSSI
0 - RSSI, dBm
Technical MP
Temperature
0 - Temperature, °C
Temperature2ndgen
0 - Temperature, °C
Touch
0 - Touch, 1
Contact
0 - Contact state, open/closed
The state change is sent immediately, not polled
Water
TBD
The BTINY MP has the following specific parameters:
Local ID
Sensor ID, received from the gateway.
Transmit Period
Some of the BTiny sensors store certain number of measurements and send them during a single radio transmission to reduce the power consumption. These sensors have standard Log Interval setting and additional Transmit Period setting. The Transmit Period is always a multiple of a Log Interval. Both parameters can be selected from preselected lists, they cannot be set freely. The number of choices for Loge Interval depends on the Transmit Period selected.
Contact MP
The BTiny contact MP has specific characteristics.
This MP observes the open/closed contact state and sends the message immediately after the state changes. Therefore, this MP type has no log period. The alarm from this MP type is raised when a selected state lasts longer than the limit set in minutes.
The MP below will raise an alarm if the state is open for more than 2 minutes.
The graph view
The list
The activity log
Last updated